SECTION 5—WHEELCHAIR OPERATION
P9000
™
XDT
28
Part No. 1118386
SECTION 5—WHEELCHAIR
OPERATION
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Set-up/programming of the Electronic Control Unit is to be performed ONLY by a
qualified technician. The fine tuning adjustments of the controller may affect other
activities of the wheelchair. Damage to the equipment could occur under these cir-
cumstances. IF UNQUALIFIED INDIVIDUALS PERFORM ANY WORK ON
THESE UNITS, THE WARRANTY IS VOID.
SPJ™Joystick Switches and Indicators
NOTE: For the following information, refer to FIGURE 5.1 on page 29.
Multi Function Charger Port
The multi function charger port is located at the front of the joystick housing. This
provides easy access for charging the wheelchair batteries. This port also serves as the
Remote Programmer Communication connection.
On/Off Toggle Switch
This toggle switch is located at the back of the joystick housing.
Speed Control switch
The speed control switch is located on the back of the joystick housing. This rotary switch
is used for controlling the speed and acceleration of the wheelchair.
1. Turn the switch clockwise to increase the speed of the wheelchair.
2. Turn the switch counterclockwise to decrease the speed of the wheelchair.
Joystick
The joystick has proportional drive control, meaning that further the joystick is pushed
from the upright (neutral) position, the faster the wheelchair moves. Your top speed,
however, is limited by the setting of the speed-control knob and programmed settings.
To slow the wheelchair to a stop, simply release the joystick. The wheelchair has
automatic speed and direction compensation to minimize corrections.
