Invacare LiNX DLX-REM400, Руководство пользователя

Страница: 115 / 128

Usage
Battery synchronisation
NEW Batteries Only—The wheelchair power must be
on during charging to ensure that accurate battery
charge levels display on the remote. New batteries
must be charged fully. The Battery synchronization
Procedure MUST be performed within 24 hours
of powering on the wheelchair. The Battery
synchronization procedure can be found in the LiNX
service manual and must be performed by a provider
or qualified technician.
5.24.1 Battery alarms
Three battery alarms are shown on the right-hand side of
the status bar:
Over voltage
This is displayed if the batteries are overcharged.
Disconnect the battery charger immediately.
Low voltage
This is displayed if the batteries are empty. Power down
the wheelchair and charge the batteries immediately.
Deep discharge
This is displayed if the battery voltage falls below the
voltage set by Cut Off Voltage. This indicates that the
battery is empty and battery damage occurs if the
battery is discharged any further. The horn also sounds
once every ten seconds for the duration of active deep
discharge status. Power down the wheelchair and charge
the batteries immediately.
5.25 Using the USB charger
CAUTION!
Risk of injury
If you use mobile phone while operating mobility
device, accidents could lead to injury or property
damage.
– Only use mobile phone in conjunction with
hands-free equipment to operate mobility
device while driving.
1637423-H 115