SECTION 4—FOOTREST
Part No 1134872
25
Crossfire
™
Series Wheelchairs
Installing/Adjusting Optional Clamp on Raised Footrest
NOTE:
For
this
procedure,
refer
to
FIGURE 4.2.
Installing
1. Install
the
two
half
clamps
onto
either
side
of
the
wheelchair
frame
approximately
2
‐
inches
above
existing
footrest
with
two
provided
allen
screws.
2. Repeat
for
the
opposite
side
of
the
wheelchair.
3. Slide
the
clamp
on
raised
footrest
into
the
half
clamps
to
the
desired
height.
4. Securely
tighten
the
four
allen
screws.
FIGURE 4.2
Installing/Adjusting Optional
Clamp on Raised Footrest
Adjusting
1. Loosen
the
four
allen
screws.
2. Adjust
clamp
on
raised
footrest
to
the
desired
height.
3. Securely
tighten
the
four
allen
screws.
Replacing/Adjusting Optional Adjustable Angle
Footrest
NOTE:
For
this
procedure,
refer
to
FIGURE 4.3
on
page 26.
Replacing the Footrest
1. Loosen,
but
DO
NOT
remove,
the
allen
screw
of
the
two
clamps
that
secure
the
footrest
to
the
wheelchair
frame.
2. Slide
the
existing
footrest
tubes
out
of
the
wheelchair
frame
and
install
new
footrest
by
reversing
this
step.
3. Position
the
new
footrest
to
a
determined
height.
4. Tighten
the
allen
screw
of
the
two
clamps
that
secure
the
footrest
to
the
wheelchair
frame.
5. Adjust
the
footplate
to
the
desired
position.
Refer
to
Adjusting
Footplate
Angle
on
page 26
and/or
Adjusting
Footplate
Depth
on
page 26.
Allen
Screws
Wheelchair Frame
Outside
Footrest
Hoop
Half Clamp
Raised
Footrest
