Invacare 6263, Инструкция по сборке, установке и эксплуатации

Страница: 5 / 16

Part No 1118382
5
Leg Extensions and
Wheeled Walker Accessories
NOTE: When properly installed, the tube edge
will rest inside the top edge of the new glide tip.
If the tube edge is visible, the tip is not properly
installed.
3. Insert the new glide tip firmly into the
leg extension.
4. Ensure the new glide tip is properly
installed as shown in Detail ʺ A ʺ of
FIGURE 3. If necessary, tap new glide
tip into position.
5. Press the snap button and install the leg
extension with new glide tip onto the
walker frame leg. Ensure that the snap
button of each leg fully protrudes
through the desired adjustment hole and
legs are adjusted so the walker sits level.
6. Repeat STEPS 1 ‐ 5 on remaining rear leg
extension.
FIGURE 3 Installing the Glide Tip
Replacing Fixed Wheels/Swivel Casters
NOTE: For this procedure, refer to FIGURE 4 on page 6.
NOTE: Refer to Installation Warning on page 2.
Fixed Wheels - Model Nos. 6270 and 6271
1. Position one wrench on the hex screw and remove the locknut by using the other
wrench and turning counterclockwise.
2. Remove the washers, wheel, bushing and hex screw that secure the wheel to the leg
extension.
3. Inspect washers, bushing and hex screw for wear and/or damage and replace if
necessary.
4. To install new wheel, reverse STEPS 1 ‐ 2.
Swivel Casters - Model Nos. 6273 and 6267
1. Grip leg tube and using the crescent wrench, apply to hex nut.
2. Loosen swivel caster and unscrew from swivel caster housing.
3. Inspect swivel caster housing and leg tube for any damage. If damaged, replace
immediately.
4. Insert new swivel caster by screwing it into swivel caster housing and tightening with
the crescent wrench.
DETAIL “A”
Glide Tip
Properly Installed
Glide Tip
Improperly Installed
Leg Tube
Glide Tip
Walker
Frame Leg
Snap
Button