SECTION 4—PACKAGING, HANDLING, AND SET-UP
IVC
™
Bed Series
24
Part No 1114836
Assembling the Spring Fabric
NOTE: For this procedure, refer to FIGURE 4.5.
1. Lift the head spring away from the bed frame to give slack to the fabric.
2. Connect the spring fabric together with the links provided. Refer to FIGURE 4.5.
FIGURE 4.5
Assembling the Spring Fabric
Adjusting and Reconnecting the Head Section Pull Tube
NOTE: For this procedure, refer to FIGURE 4.6 on page 25.
1. To disconnect the head pull tube assembly from the side frame of the foot spring
remove the hitch pin, grommet/washer from the clevis pin. (Refer to FIGURE 4.6,
Detail "A".)
2. Extend the inner pull tube shaft manually until the spring button "clicks" into the
adjustment hole of the outer pull tube.
3. Connect the pull tube end assembly to the lift arm of the head spring as follows (Refer
to FIGURE 4.6, Detail "B"):
A. Insert the clevis pin into the lift arm slot.
B. Replace the grommet/washer.
C. Secure with hitch pin.
Head Spring
Fabric
Link
Fabric
Link
