50 PSI Compressor
4
Part No 642661
Electrical - Compressor
If the overload protector shuts off the motor frequently, you may have a low voltage
situation. Low voltage can also be suspected when:
1. The motor does not get up to full power or speed.
2. Fuses or circuit breakers activate when starting compressor.
3. Lights dim or remain dim when compressor is started.
4. Other motor operated appliances fail to operate properly. Too many motor operated
appliances on same circuit.
NOTE: The motor of this compressor has a thermal overload protector. If the motor should overheat,
the overload protector will shut off the motor. If this should occur, turn the ON/OFF switch to the
OFF position and allow the motor to cool (approximately 5 minutes). Restart compressor. If the
compressor fails to start, wait an additional 5 minutes before attempting to restart. If this fails,
check for a blown fuse on the household electric circuits. If the unit still does not restart, the motor
must be replaced. Call your dealer immediately.
Electrical - Extension Cords
NOTE: Make certain extension cord is in good condition and is NOT LESS than 18 gauge for 25
feet, 16 gauge for 50 feet and 14 gauge for 100 feet.
Operation
WARNING
Proper operation of this product is necessary to avoid physical harm. Improper use
can cause personal injury and/or tissue damage. This product should not be used
unless the operator has been instructed by a physician or other qualified health care
professional.
DO NOT use the compressor for continuous operation more than 10 hours, this can
result in overheating and damage to the compressor.
NOTE: For this procedure, refer to FIGURE 2.
1. Familiarize yourself with this unit.
2. Place unit on table and push down hard so that suction feet hold unit firmly in place.
3. Check to see that the ON/OFF switch is in the OFF position. Plug power cord into
electrical outlet.
NOTE: Before attempting to start a cold unit, let the unit reach room temperature in a heated area,
then press the ON/OFF switch to start the unit.
4. Turn the pressure control knob fully counterclockwise.
NOTE: As the knob is turned counterclockwise the pressure will decrease, as the knob is turned
clockwise the pressure will increase.
