Open-Q™ 820 (APQ8096) / 820Pro (APQ8096SG) µSOM Development Kit User Guide Version 1.4
33
Copyright Intrinsyc Technologies Corporation
Figure
16 On Board PCB Antennas
3.8.14 External and on-Board PCB GPS Antenna
The Open-Q 820 / 820Pro µSOM carrier board allows user the flexibility of using an
external (via SMA connector) or an on-board PCB GPS antenna. Depending on which
antenna is used, dip switch S10 needs to be configured (see table below for details).
GPS Antenna Selection
Dip Switch S10 (Position 8) Selection
On Board PCB Antenna
Off Position
External Antenna (Supports Both Active
and Passive Antenna)
On Position
If an external GPS antenna is preferred, Intrinsyc recommends the Laird Technologies
hepta-band dipole antenna (manufacture part number: MAF94300). It is important to note
that GPS should be used or tested near a window or a location where satellites are easily
“seen” by the device.
3.8.15 Open-Q Display
The display output options for the Open-Q 820 / 820Pro µSOM Development Kit consists
of:
•
An HDMI type A connector
o
HDMI 2.0 (4K60) or 4K30 Miracast
•
A 100-pin display connector J2 that supports:
ANT1
ANT2
