Intrade Line JS-981PQ, Оригинальное руководство пользователя

Страница: 9 / 22

original instructions
Page 9 of 22
Over painting.

Spray gun not clean, or not lubricated
resulting in piston being stuck in
cylinder

Too much paint

Viscosity too low

Disassemble spray gun and
, clean with thinner.

Adjust the volume clockwise
to reduce spraying. Two thin
coats are better then one

Check viscosity
Motor louder than normal.

Spray gun not clean, or not
lubricated, resulting in piston being
stuck in cylinder

Disassemble spray gun and
clean with thinner.
No spray, no sound.

No electricity

Check power supply
Operating sound not
right.

Poor output adjustment

Not enough paint in the container
resulting in air being sucked in.

Not diluting properly or not passing
pick up pipe completely.

Re-adjust

Refill with paint.

Check pick up pipe and
viscosity level.
“Orange Skin” excessive
fogging.

Incorrect solvent is used

Spray gun too far from the surface.

Paint too thick

Use correct solvent.

Hold spray gun closer to the
object.

Thin the paint
Cleaning and maintenance
Fig. G.
Always remember to disconnect from the mains supply before cleaning the spray gun or paint
container.
It is essential that the spray gun is cleaned thoroughly after every use. Failure to clean it will
almost certainly result in blockages and it may not operate when you next come to use it! The
guarantee does not cover cleaning a sprayer that has not been properly cleaned by the user.
The following action must be taken after every use:
1. Empty any remaining material from the container.
2. Clean the container thoroughly with the thinner that was used.
3. Pour some thinner into the container and spray through the spray gun until only clean
thinner is coming out of the nozzle.
4. Thoroughly clean the paint pick up pipe and filter with thinner.
5. Clean the basket and nozzle and remove any other debris or paint that remains.
6. Turn the spray gun upside down and apply a few drops of light oil to the two apertures (F).
This will lubricate the piston and cylinder.
If your spray gun should require extra internal cleaning, it may be necessary to disassemble it.
If so the following action should be taken:
1. Remove the plug from the mains socket.
2. Remove paint container, pick up pipe and filter.
3. Take off the pump assembly.
4. Release the nozzle (H), nozzle guard (I), valve (J), piston (K) and spring (L).
5. Clean the cylinder (M) and all parts thoroughly with solvent.
6. Apply a few drops of light lubricating oil to the piston, spring and cylinder.