Technical specifications
INTORQ | BA 14.0217 | 09/2019
37
5.11
Emissions
Heat
Since the brake converts kinetic energy as well as mechanical and electrical energy into heat, the surface
temperature varies considerably, depending on the operating conditions and possible heat dissipation. Un-
der unfavourable conditions, the surface temperature can reach 130 °C.
Noise
The loudness of the switching noise during engaging and disengaging depends on the air gap "s
L
" and the
brake size.
Depending on the natural oscillation after installation, operating conditions and the state of the friction sur-
faces, the brake may squeak during braking.
5.12
Hand-release
The hand-release mechanism is used to release the brake by hand and can be retrofitted (refer to In-
stalling the hand-release (retrofitting)).
The hand-release springs back to its original position automatically after operation. The hand-release re-
quires an additional air gap s
HL
in order to function; this is factory-set prior to delivery. Verify the dimension
s
HL
after the installation.
Brake completely installed
Stator (not attached to the motor)
Fig. 11:
Positions of the adjustment dimensions that must be checked
Size
S
LN
+0.1 / -0.05
S
HL
+0.1
[mm]
[mm]
06
0.2
1
08
10
12
0.3
1.5
14
16
18
0.4
2
20
25
0.5
2.5
Tab. 12:
Adjustment setting for hand-release
