82810 18 07/21
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
GB
10
2 Initiation
2 .1 Scope of application
CAUTION!
Risk of injury! Damage to the cutting me-
chanism!
The shredder should mainly be fed with
paper or cardboard!
Other materials according to the data sheet:
Only shred in small amounts and not per-
manently. Shredding other data carriers
can cause injury (e.g. by splintering of hard
materials) or may damage the shredder (e.g.
destruction of the cutting system).
Der Datenshredder
intimus 200CP5/H200CP4
shred-
der is used in all areas where large quantities of prin-
ted material need to be shredded.
The machine (model H200CP4) can shred cardboard
and crumpled paper as easily as it shreds smooth pa-
per.
2 .2 Installation
NOTE!
Be certain that three phase current is available
at the point of installation (see
„Technical data“,
p. 14
for information concerning required
pre-fusing of the electrical outlet).
Proceed as follows:
1 .
Unpack and set machine upright.
2 .
Mount the hopper extension (
fig. 1/1
) (see descrip-
tion below).
3 .
Put the collecting bag into the sliding frame (see
description
„Emptying the collecting bag“, p. 12
)
4 .
Plug in the machine.
2 .3 Assembly of the hopper extension
(Modell H200CP4)
Take the hopper extension (
fig. 1/1
) out of the cabinet
and place it as shown on top of the hopper (
fig. 1/2
). Fix
the hopper extension with the four provided screws to
the hopper itself.
CAUTION!
Risk of injury!
For access safety reasons the machine must
only be operated if the hopper extension is
assembled to the hopper (
fig. 1
).
1
2
000294
1
hopper extension
2
hopper
fig. 1 Assembly of the hopper extension
2 .4 Power supply connection
• The maximum value for loop impedance at the
mains connection point is 0.5 Ohms.
• The conductor cross-section of the power supply
line should be of a magnitude so as to cause a 15%
voltage drop in the case of a machine blockage (in-
hibit current = 6 x nominal current).
2 .5 Checking the running direction
1 .
Move the main switch (fig. 2) to position „1“.
2 .
Press the „forward“ button (fig. 3/3). The cutting
system starts running.
3 .
Check that the cutting system is running in the cor-
rect direction and correct the phase relation of the
power plug if necessary.
DANGER!
Risk of death by electrocution!
Correcting the phase relation of the power
plug may only be carried out by a qualified
electrician!
Now that everything has been correctly assembled
and connected, you can proceed to operating the ma-
chine.
