Intimidator GC1K S1, Инструкция по эксплуатации

Страница: 68 / 92

PAGE 70
Power Steering (if equipped)
7KH,QWLPLGDWRU*&.6WDJHDQG6WDJH
FRPHH quipped with power steering made by UniSteer
Performance Products.
Diagnosis Trouble Code Reading and Code Clearing
1. Verify that your trouble code light is on steady.
2. Next, take your dark purple wire and hold it to a good
clean ground. You will have to make sure it is a solid
ground to get the LED to blink or flicker, and you may
have to use a jumper wire to extend the wire’s length.
Once you see the LED flicker or blink, wait for LED to
start blinking a code.
3. The light will flash in a sequence like 1 and then 123.
This code flash would be interpreted as a code 13. The
code will repeat itself 3 times and then go to the next
code if there is one in the system. You need to wait until
all the codes are read and recorded.
4. Turn off the unit and turn back on. Once light is lit and
staying on, touch the dark purple wire 6 times in a row
to a ground. After the 6 times turn unit off and turn
back on. Codes should be cleared with the unit working
properly. If not continue to step 5.
5. Double check the codes using steps 1 through 3. Once
you know what the codes are you can use this chart to
tell where or what the problem may be.
6. Once you have determined what the problem is and
make the necessary repairs the unit should work
normally. If the light is still on after the repair you will
need to clear the codes using step 4.
Trouble Code Problem Diagnosis
41-42-43-44-45-51 Electric motor
malfunction
Replace Motor Assembly
11-13-14-15 Torque Sensor Replace Motor Assembly
52-54-55 ECU Malfunction Change Computer
22 No Engine Input Change Computer
21-23-24 No Speed Signal Change Computer
12 Wiring or Electrical
Verify 12 volts at small
red wire. Verify good
ground. Solder all
connections. Check
for bad connections or
broken wires.
PAGE 68