254
A
S AVE THESE INSTRUCTIONS
(254IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 01/28/2016
English
Page 11
SET UP
(continued)
Spa Control Unit Installation
1.
Connect the spa control unit to the spa tub
(see drawing 10)
. Hand-tighten the connectors securely.
Do not use tools to tighten.
2.
Reinstall the back cover
(2)
to the spa control base
(see drawing 11).
Back cover must be installed
before using the SPA.
CAUTION:
Do not sit, lean, cover or place any objects over the spa control unit.
3.
Attach
the
fi
lter cartridge housing assembly to the inside of the spa
tub outlet grid (lower position, marked “C”)
(see drawing 12).
In
fl
ate
the spa tub
fi
rst before installing
fi
lter pump
fi
ttings.
4.
Before
fi
lling with water ensure the bottom drain valve caps are
securely closed on the inside and outside.
5.
Fill the spa tub with freshwater to a level between MIN and MAX
marked on the inside of the spa wall. Do not over
fi
ll the spa. Never
move the spa tub with water inside and/or with the control base
attached to the spa as the spa or control base may be damaged.
WARNING:
Never pour water with a temperature higher than
40°C (104°F) into the spa directly. It is recommended to
fi
ll the
spa tub with lukewarm water for quick heating and energy saving.
6.
Place the spa cover and spa air bladder (pre-installed in spa cover)
over the spa tub, and make sure the spa cover buckles are locked
using the key provided after pulling the buckled straps tight.
IMPORTANT:
Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
7.
Ensure the spa is plugged into a electrical socket and press the button to turn on the control unit
panel
buttons
fi
rst. Press the button on the control panel to activate the heater, see “Spa Control
Unit Panel” operation section.
11
2
10
A
B
C
B
C
A
12
C
