Intex Avatar 3D 2.0, Руководство пользователя

Страница: 6 / 20

6
4. Getting Started
4.1. The battery cover
Schematic diagram of installing and uninstalling:
4.2. Batteries
The battery is included in the package. It is not fully charged out of factory
but it may still be able to power on your phone. Please completely use up
the power of the battery and then charge it for at least 12 hours with your
phone turned off. Your battery will reach its optimal state after three cycles
of charge and discharge.
4.2.1. Installing and uninstalling the battery
To install the battery, remove the back cover from the phone by pressing
firmly on the cover and slide it down. Align the golden contacts of the
battery to the contacts in the phone, and then gently snap down the battery
into place. Re-assemble the back cover.
To uninstall the battery, flip the battery out from the bottom of the battery.
Schematic diagram:
4.2.2. Charging the battery
Plug the charger into the socket on the side of your phone. Connect the
charger to an AC wall socket. The blinking of the battery level icon indicates
the battery is being charged. When the blinking stops, it indicates the
charging is finished.
During charging, the phone and charger will feel warm to the touch. This is
normal.
Warning:

The operating ambient temperature range of the charger is 0  C-50  C.
Do not use the charger when the temperature exceeds this limit.

To ensure safety use the charger approved by the phone manufacturer
only. Failing to comply with this will violate the terms and conditions of
the warranty.