4
Intex ASG18V
intex.com.au
|
intex.co.nz
General safety rules
• Do not expose charger to water, rain or snow.
• Use of an attachment not recommended or sold by
the battery charger manufacturer may result in a risk
of fire,electric shock, or injury to persons.
• To reduce risk of damage to electric plug and cord,
pull by plug rather than cord when disconnecting
charger.
• Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
• An extension cord should not be used unless
absolutely necessary. Use of improper extension cord
could result in a risk of fire and electric shock.
If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number,
size, and shape as those of plug on charger;
b. That extension cord is properly wired and in good
electrical condition; and
c. That wire size is at least as large as the one specified
in the table.
• Do not operate charger with damaged cord or plug.
If damaged, have replaced immediately by a qualified
serviceman.
• Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman.
• Do not disassemble charger or battery cartridge;
take it to a qualified serviceman when service or repair
is required. Incorrect reassembly may result in a risk
of electric shock or fire.
• To reduce risk of electric shock, unplug charger from
outlet before attempting any maintenance or cleaning.
ADDITIONAL SAFETY RULES FOR CHARGER &
BATTERY CARTRIDGE
Do not charge battery cartridge when temperature is
BELOW 10˚C (50˚F) or ABOVE 40˚C (104˚F).
• Do not attempt to use a step-up transformer, an
engine generator or DC power receptacle.
• Do not allow anything to cover or clog the charger
vents.
• Do not use tool without Danger Label on tool. If label
is missing, damaged or unreadable, contact your
representative to obtain a new label at no cost.
• Do not operate charger with damaged cord or plug.
If damaged, have replaced immediately by a qualified
service man.
SPECIFICATIONS
Rated Voltage
DC 18V
Drill capacity
#6-#9’ 3/4”(19mm)~2 3/16”(55mm)
No load speed
0~4800 min
-1
Fastener capacity 50 Screws / one strip
Vibration
Less than 2.5m/sec
2
Battery Model No B186 Lithium-ion
Charger Model No C186
PRECAUTIONS ON USING YOUR
CORDLESS TOOL
This product contains batteries which must be
disposed of
properly.
1. Be aware that this tool is always in an operating condition,
because it does not have to be plugged into an
electrical outlet.
2. Fully charge the battery for better operation.
3. Be sure the battery is snapped in place.
4. When not in use, lock the switch.
5. When operating at a high place, be aware of things
below and around you.
6. Before drilling into walls, ceilings, or floors, ensure that
there are no concealed power cables inside.
IMPORTANT SAFETY INSTRUCTIONS FOR
CHARGER
Save These Instructions
Input: Only use the rated voltage marked in charger.
IMPORTANT SAFETY INSTRUCTIONS FOR
CHARGER
1. Charging Output : MAX DC21V
Charging Current : MAX 2.8A
Charging time : 3.0Ah : 68min
Charging lnput : 120 V 60HZ
NOTE:
The charging time may vary according
to an ambient temperature and power source
voltage.
2. Before charging, study the instruction sheet;
3. Disconnect the supply before making or breaking
connections to the battery;
4. For indoor use or do not expose to rain (for
ordinary battery chargers).
5. Correct use: Universal fast chargers are to be
used exclusively for charging 18V serious
rechargeable battery packs. Any other may
result in risk of fire, electric shock or electrocution.
The user bears sole responsibility for any damage
caused by inappropriate use.
The generally recognized accident prevention
regulations and the safety instructions which
accompany them must be adhered to.
• Use only C186 chargers for charging System
B186 packs. Do not use battery packs from
other systems.
The following battery packs can be charged
with this charger.
DANGER
: High voltage present at
charging terminals. Do not probe with
conductive objects. Danger of electric
shock or electrocution.
DANGER:
If battery pack case is cracked or
damaged, do not insert into charger. Danger of
electric shock or electrocution.
Cracked
