(150IO) AP620C ELECTRIC PUMP ENGLISH 4.875” X 7.25” 05/06/2021
English
150
IO
SAVE THESE INSTRUCTIONS
Page 3
INFlATION
1. Plug in the AC line cord into an AC electrical outlet. See Fig
(1)
.
2. Slide the switch left to the inflation mark (
). See Fig
(2)
.
3. When the airbed is fully inflated to the desired firmness, slide the switch right to the Off
mark (
).
4. Lie down on the airbed to test the firmness.
5. If the sleeping surface is too hard, adjust the firmness by slowly sliding the switch right
to the deflation mark (
). See Fig
(4)
. Slide the switch left to the Off mark (
)
when the desired firmness is achieved. See Fig
(5)
. If the airbed becomes too soft
repeat step #2 thru #5 as necessary.
FIg (1)
110 -120 V
220 – 240 V
FIg (2)
6. Disconnect the AC line cord from the wall socket, place it inside the cord compartment.
FIg (5)
FIg (4)
FIg (3)
√
Never disconnect the power line cord from the electrical outlet while the pump is operating.
Switch OFF (
) the pump first before disconnecting the power line cord.
IMPORTANT
