4
INSTALLATION GUIDE
4. IntesisHome
®
device installation procedure
If you have an Aquarea Bibloc model, please see section 4.1. On the other hand, if you have an Aquarea
Monobloc model, please move to section 4.2.
4.1 Connection to Bibloc Aquarea indoor unit
1. Unplug the Aquarea system from the power supply line.
2. Detach Control Panel’s cable from the Indoor Unit Electronic Controller Board (CN-Remote
connector, see Figure 3). Please see the document at http://www.intesishome.com/docs/PA-AW-
WIFI-1-Aquarea-Install.pdf
3. Open the top lid of the IntesisHome
®
device.
4. Remove the top hole IntesisHome
®
cable cover (see Figure 1)
5. Connect Panasonic’s Control Panel cable
in the IntesisHome
®
Device K2 connector.
Insert the cable through the IntesisHome®
top hole for cable use to correctly set the
connection cable.
Use the cable holes on the bottom of the
Indoor Unit to pass the cables through
(see Figure 3).
6. Connect one end of the IntesisHome
®
Device cable, supplied in this package,
in the K1 connector of the IntesisHome®
Device itself and the other end into the
Indoor Unit as if it was Panasonic’s Control
Panel cable (CN-Remote connector).
Insert the cable through the IntesisHome
®
top hole cable to correctly set the
connection cable (see Figure 3).
7. Close the IntesisHome
®
lid again.
8. Plug the Aquarea system to the power
supply line.
Installation process should
only be performed by an
authorized installer
Important: Please follow all Safety
Instructions provided by the Panasonic
service manual and/or installation manual.
Important: Use only the cable attached. Extending or shortening the connecting cable included
with the interface may cause it to malfunction. Keep the connecting cable as far away as possible
from electrical wires and ground wire. Do not bundle them together.
Figure 3.- IntesisHome
®
Device and Aquarea
Bibloc connection diagram
IntesisHome
®
PA-AW-WIFI-1
Indoor Unit
CN-Remote
connector
IntesisHome
®
device
To K1
connector
To K2
connector
Panasonic
cable
IntesisHome
®
cable