IntesisBox
®
KNX - Modbus RTU master
Doc. Rev.2
Installation Manual
URL
tel
http://www.intesis.com
[email protected]
+34 938047134
2 / 5
This information is subject to change without notice.
1. Separate the fixing clips in the bottom of the box, pushing them to the outside until hear the "click" which
indicates that now the clips are in position for wall mount, see in the figure below.
2. Use the holes of the clips to fix the box in the wall using screws. Use the template below for the wall holes.
With the clips of the box in their original position, insert first the box in the upper edge of the DIN rail and later insert
the box in the down part of the rail using a small screwdriver and following the steps n the figure below.
Wall mount
Clips in their original position, for DIN rail
mount
Clips in position for wall mount
DIN
Rail
1
2
3
Top view of the box
IntesisBox
®
www.intesis.com
61 mm
100 mm
Ø 3 mm
DIN rail mount
Side view of the box
Botton view of the box
