InterVac IVD660-F, Инструкция по установке и эксплуатации

Страница: 9 / 13

9
HOW TO OPERATE YOUR MODEL: IVD-660
This appliance is equipped with an automatic-reset thermal protector to protect the motor
from overheating due to a blockage in the vacuum tools or hose. In the event the thermal
protector operates due to the motor overheating, do the following. Turn off the unit and
unplug it from the wall (required to reset the thermal protector). Inspect and remove any
blockage. Allow the appliance to cool down, then plug the appliance back in and resume
using.
PLEASE NOTE: NORMALLY A CENTRAL VACUUM CLEANER IS STARTED WITH THE VACUUM VALVES AROUND
THE HOUSE WALLS. WITH THE INTERVAC YOU CAN ALSO UTILIZE THE VALVE IN THE DOOR OF THE POWER
UNIT TO CLEAN YOUR GARAGE OR CAR USING THE on/off SWITCH.
A: IMPORTANT:
DO NOT TURN SWITCH ON AT VACUUM, WITHOUT VACUUM HOSE ATTACHED OR
VALVE OPEN.
Use On / Off Switch only with vacuum hose attached
1. To start the vacuum cleaner, push the switch to the “I” position.
2. To stop the vacuum cleaner, push the switch to the “O” position.
B: Connecting and disconnecting the hose at the POWER UNIT
.
1. Lift the inlet (utility)valve cover on the front of the door.
2. Insert hose cuff with a twist and push to secure.
3. To remove, with one hand hold the door in place, and with the other turn hose in either direction
while pulling hose towards you.
C: How to change the dust bag,
DO NOT REUSE DUST BAG
Replacement bag: Part # Y20 high filtration 5-layer fiber bag.
1. Take the door off the vacuum cleaner, by pulling the arched handle on top of the door towards you.
2. Pull the front collar holder (on dust bag) out and down. See page 10, pic 6 and 7.
Pull the top collar (white) down from the pipe and remove dust bag form the collar holder.
3. Discard full bag
4. Now slide the green front collar of a new bag into the holder all the way into the groove. See below.
5. With both hands behind the bag hold the white top collar. In an angle slide the collar onto the small ledge in
the back behind the pipe. See arrow in picture 3 and 4. Lift the collar up and push up as high up as possible.
6. Now insert the collar holder with the green collar into the cavity on top, see page 10, pic 5,6 and 7
7. The last thing to do, please push the front collar up so it is in the center of the holder. Page 10, pic 8.
Collar holder