Paper Template: # W601 or # W602
for flush mounting
Paper Template: # W600
for surface mounting
see page 8
Minimum height 6” from floor
3
Tape template to wall
Fig.: A
Fig.: B
MODEL: CM120 (with detachable cord) or H120 surface
mounted with power cord attached
TIP:
External to Wood Surfaces:
External to Drywall (½ thick) Surfaces:
if you do not like to surface mount the vacuum with screws you can use Velcro, ask for our kit # A015
(see Fig.: A)
(see Fig.: A)
Step 1.
Step 2.
Mark the 4 centers accurately.
Step 3.
Step .
TIP:
Step .
Step 1.
Step 2.
#W600
Step 3.
Step 4.
Step 5.
Step 6.
Very lightly
Step 7.
not
Step 8.
Step 9.
TIP:
4
If vacuum cleaner is mounted on its back or side or very low, it may slide off the screw heads when you pull too hard on the
vacuum hose. To prevent this, fasten a small block against the top of the unit.
5
If vacuum cleaner is mounted on its back or side or very low, it may slide off the screws heads when you pull too hard on the
vacuum hose. To prevent this, fasten a small wood block against the top of the unit.
To cover with the vacuum hose as much area as possible, choose a wall or surface that is centrally located
and has an electrical outlet close by.
Cut paper template from instruction manual, page 8. Tape the template to the wall or a surface at a comfortable
operating height or a minimum of 6 inches above the floor.
Carefully remove template from the wall and place it into the operating manual for future references .
Attach the enclosed #8 screws to the wall as marked on the template. Keep the screw heads 1/8” from the wall.
Slide the key holes on the back of the vacuum cleaner over the 4 screw heads and secure by pushing down.
If vacuum cleaner is loose re-tighten screws.
Check to be sure dust bag and motor filter (under dust bag) are in place.
To cover with the vacuum hose as much area as possible, choose a wall or surface that is centrally located
and has an electrical outlet close by.
Tape the paper template
on page 8 to a wall at a comfortable operating height or a minimum of 6 inches
above the floor.
With an awl or similar object mark the center of the key holes
. Carefull remove template from the
wall and place it into the operating manual for future references .
With a 3/32 drill bit, pre-drill all 4 holes.
Now use a 5/16 drill bit to enlarge the 4 holes to the correct size.
Squeeze the two arms of the anchor together and insert through the hole.
hammer the anchor
with the dry-wall surface.
Insert the red key-pin to toggle the anchor open behind the dry-wall, remove red key. Do
hammer key.
Attach the four screws (#8) through the anchors into the wall. Keep the screw heads 1/8” from the
wall surface.
Slide the key holes on the back of the vacuum cleaner over the 4 screw heads and push down.
If the vacuum cleaner is loose on the screws re-tighten screw heads a little more.
y
accurately
flush
Содержание CM-120
Страница 8: ...10...
