9
Main Unit Setup
To enter the Main Unit setup mode, press and hold all 3 buttons of chan-
nel 1 while turning on the mains power. When all setup programming has
been completed, press the ‘Group B Go’ button to exit and save changes.
Set Main Unit Address.
The current Main Unit address is displayed using the fault LEDs of chan-
nels 1 to 8. If address #5 is programmed, then fault LED #5 will be on.
Change the address by pressing the ‘Dimmer’ button. Valid addresses are
1 to 8. Unless the RS232 adaptor unit is used, the address can be set to
any value. Factory default address is #1
Calls from Outstations.
The ability for the Main Unit to receive calls from Outstations can be
turned off or on (i.e. when the ‘Confirm’ button is pressed at any Outsta-
tion, the ‘Standby’ and ’Go’ buttons assigned to that Outstation will flash
on the Main Unit . When the Main Unit is in setup mode, the status of this
function is displayed by the channel 2 ‘Go’ button. The factory default =
LED on (enabled). Use the channel 2 ‘Go’ button to toggle this on and off.
Enable/disable the Beep Button.
When the Main Unit is in setup mode, the status of this function is dis-
played by the channel 3 ‘Go’ button. The factory default = LED on
(enabled). Use the channel 3 ‘Go’ Button to toggle this on and off.
Link/unlink the Master Group A and B Buttons.
The Master Group buttons are normally linked between multiple Main
Units. When the RS232 Interface Unit is connected, it may be desirable to
have the Main Units not linked. This option is only possible when the
RS232 Interface Unit is connected. When the Main Unit is in setup mode,
the current status of this function is displayed by the channel 4 ‘Go’ button.
The factory default = LED on (linking enabled). Use the channel 4 ‘Go’
Button to toggle this on and off.
