Thrii
Installation
Page
22
of
23
All information including dimensions, changes in design and material are subject
to manufacturer’s change without formal notice and without obligation. Intersan
assumes no responsibility for use of superseded or voided information. Verify all
rough-in information before installation. It is the responsibility of the installer to
conform with local and national codes.
Intersan Manufacturing Company
1748 West Fillmore St., Phoenix, AZ 85007
Phone: 800-999-3101 Fax: 602-254-1776
intersanUS.com
THRII-inst-Rev1
by
6.
For further adjustments repeat steps 1 to 5, or to exit the programming mode momentarily press the Menu
Select button. A 20 second period of inactivity will automatically exit the programming mode and revert to
displaying the time.
Instructions can be downloaded from the Wallgate web site or contact Intersan to:
Restore the unit to factory default settings.
Instructions to change the cycle sequence of soap – water – hand dryer.
8.
Care, Routine maintenance, Service & Repair
The Thrii Hand wash dryer unit is well designed and manufactured from high quality materials. If you install, operate and
maintain them according to the instructions given in this manual, the unit will give reliable and efficient service. If you
need any further information or advice, please contact Wallgate Customer Services.
8.1.
Routine maintenance
The following routine regular maintenance in between service intervals will help to prevent premature parts failure:
Flush the soap pump system with warm water to remove congealed soap within the pump, tube & soap nozzle.
Clean the external surfaces of the soap nozzle to remove congealed soap.
De-scale the water spray nozzle.
Clean the lens on the infra-red hand sensor.
Clean the waste outlets on the basin bowl and flush out / clean the waste sump.
Clean & de-scale the wash bowl.
Check the unit functions of soap, water and dryer dispensing are operating correctly. Any malfunction must be
reported so that service repair work can be arranged to avoid further potential damage to the unit.
Switch OFF the electrical power to the unit in the event of a serious fault or if the unit fails to operate.
8.2.
Service and Repair
Any service or repair work must be done by a qualified engineer. During the warranty period, the service or repair must
only be done by an Intersan engineer or appointed service agent. Refer to the Wallgate Limited Terms and Conditions for
warranty information.
Service warning indicator:
The LCD display shown on fig 18 will show “Ser” when a recommended service is required or
alternatively it is recommended that the unit is serviced every 56000 cycles or a minimum of once per annum.
Service warning indicator reset:
Press & hold buttons 2 & 4 together for 4 seconds.
Any service or repair work must be done by a qualified engineer. During the warranty period, the service or repair must
only be done by a Wallgate engineer or appointed service agent. Refer to the Wallgate terms and conditions for warranty
information.
