Thrii
Installation
Page
13
of
23
All information including dimensions, changes in design and material are subject
to manufacturer’s change without formal notice and without obligation. Intersan
assumes no responsibility for use of superseded or voided information. Verify all
rough-in information before installation. It is the responsibility of the installer to
conform with local and national codes.
Intersan Manufacturing Company
1748 West Fillmore St., Phoenix, AZ 85007
Phone: 800-999-3101 Fax: 602-254-1776
intersanUS.com
THRII-inst-Rev1
by
1.
Remove the fascia from the packing box.
2.
With one person holding the fascia, the second person should extend the hinge components on the right side of the
fascia so they are fully extended. Position the fascia assembly so the two hinges are suspended next to the hinge side
lock plates mounted on the support frame.
Have one person hold the fascia so it is suspended where the hinge halves on the fascia are in alignment with the
halves attached to the mounting frame, hook each of the hinges on the fascia side around the corresponding bar each
hinge on the mounting frame side, and latch each hinge.
CONTINUE SUPPORTING THE FASCIA UNTIL YOU HAVE
VERIFIED THAT THE HINGES ARE ATTACHED AND SECURE.
Continue supporting the weight of the fascia, and test the ability of the fascia to swing freely on the hinges. If any
binding or limitation in the range of motion occurs, check each of the two hinges to ensure they are fully attached and
secure (see figure below).
3.
Engage the ‘Hinge release lock’ spigot, fitted to each hinge to prevent accidental hinge latch release.
