Interpack HSD2000-ET II MIRROR, Руководство по эксплуатации и список запасных частей

Страница: 21 / 67

UH179TW / UH679TW UDH179-02
21
S
ET
-U
P
P
ROCEDURES
One Way Clutched Roller Adjustment
This one direction, tensionable roller
assures that proper tension is present when
cutting the tape. It is preset at the factory
but should re-adjustment be necessary,
follow these steps:
1. Decrease all mandrel tension.
2. Decrease all one way clutched roller
tension.
3. Process a case through the machine. It
should not cut tape.
4. Gradually, apply a very small amount of
tension to the one way clutched roller
until the tape is cleanly cut as the case
processes.
5. Too much tension will cause the tape to
wrinkle or snap back.
6. Too little tension will not cut the tape.
Figure 7-12
UUU
Main Spring Adjustment
The main spring tension is set at the factory.
This setting should be optimal for most
applications. Environments where a
different setting is desirable would be:
1. Void filled cases would need a lighter
wipe down pressure.
2. Overfilled cases might require additional
wipe down pressure.
3. Double wall corrugated might need
additional wipe down pressure to
overcome the memory of the major flaps.
4. Thinner walled corrugated cases might
require less wipe down pressure.
5. Faster line speeds would need additional
spring tension to provide a quicker wipe
down of the rear tape leg.
Should the need arise to increase or
decrease the wipe down pressure, follow
these steps:
1. Remove main spring (Item #1) .
2. Loosen the flathead countersink screw
(Item # 2) .
3.
Relocate to the higher hole to decrease
force or to a lower hole to increase force.
Figure 7-13