Page 10
AIR CONDITIONER USE
----------------------------------------------------------------------------------------------------------------------------------
Cool Mode Feature
Use the
Cool
mode at
Low, Med, High
or
Auto Fan
Speed
for cooling. Use the
Temperature Increase
/Decrease
pads to set the desired temperature between
64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off to
keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
NOTE
:
If the air conditioner is off and is then turned on while set
to a
Cool
setting or if turned from a fan setting to a
Cool
setting, it may take approximately 3 minutes for the
compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling
—Select the
Cool
mode -
Low
or
Med
fan speed - Select a normal cooling temperature.
For Maximum Cooling
—Select the
Cool
mode -
High
fan speed - Select a lower set temperature.
For Quieter and Nighttime Cooling
—Select the
Cool
mode -
Low
fan - Select a middle set temperature.
----------------------------------------------------------------------------------------------------------------------------------
Energy Saver Mode Feature
ON
—The fan will cycle on and off with the compressor.
This results in wider variations of room temperature and
humidity. Normally used when the room is unoccupied.
NOTE
: The fan may continue to run for a short time after
the compressor cycles off.
OFF
—The fan runs all the time, while the compressor
cycles on and off.
----------------------------------------------------------------------------------------------------------------------------------
Fan Only Mode Feature
Use the
Fan Only
Mode at
Low, Med
or
High
fan speed
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a
Set
temperature cannot be entered. The room temperature
will appear in the display.
NOTE
: Auto Fan Speed cannot be used when in the
Fan
Only
Mode.
----------------------------------------------------------------------------------------------------------------------------------
Auto Fan Speed Feature
Set to
Auto
fan speed for the fan speed to automatically
set to the speed needed to provide optimum comfort
settings with the set temperature. If the room needs
more cooling, the fan speed will automatically increase.
If the room needs less cooling, the fan speed will
automatically decrease.
NOTE
: Auto Fan Speed cannot be used when in the
Fan
Only
Mode.
----------------------------------------------------------------------------------------------------------------------------------
Power Outage Recovery Feature
In the case of a power outage or interruption, the unit will
automatically restart in the settings last used after the
power is restored. If the
Delay 1–24hr
feature was set, it
will resume countdown. You may need to set a new time
if desired.