Intermec PB3 Series, Руководство пользователя

Страница: 20 / 38

10 PB3 Mobile Printer User’s Guide
2 Insert the belt loop knob into the connector slot on the belt loop
and slide the printer down until the knob clicks into place.
3 To disconnect the printer from the belt loop, press both of the
connector latches and slide the belt loop knob out of the slot.
Printing a Configuration Test Page
Once the battery is charged and paper is loaded, you can print a
configuration test page. Use this information for reference when
installing the PB3 and to verify correct printer operation. If you
cannot print the test page, see
“Troubleshooting” on page 18.
To print a test page
1 Make sure the printer is off before you begin.
2 Press and hold the Feed button.
3 Press the Power button once to turn on the printer. When the
printer starts printing the test page, release the Feed button.
4 To stop or cancel printing the test page, press either the Power or
Feed button.
Note: Do not try to remove the printer from the belt loop without
pressing both latches.
Note: If you are using the AC adapter/charger as a power source, the
printer will not print unless a battery is installed.