Intermec MobileLAN power 12, Руководство пользователя

Страница: 26 / 46

2-6
Shelf Mounting
When shelf-mounting the 12-port Power Bridge, the self-adhesive
rubber feet provided in the kit should be placed on the underside of the
Power Bridge. Be sure to place the rubber feet on the provided 90°
angle marking in order to ensure stable placement.
No more than four (4) Power Bridges are to be placed on top of one
another if the units are shelf-mounted.
The 6-port Power Bridge is provided with rubber feet already in place.
Setting Up the Power Bridge
This section covers the following topics:
•
Powering up
•
Connecting cables to the Power Bridge
•
Connecting cables to end devices
Powering Up
This section describes how to power up the Power Bridge.
Note: The Power Bridge has no ON/OFF switch. To connect or
disconnect power to the Power Bridge, insert or remove the
power cable from the AC power receptacle on the rear of the
Power Bridge.
To power up the Power Bridge
1. Insert a power cord into the power socket on the rear of the Power
Bridge.
2. Insert the other end of the power cord into the power receptacle.
The Power Bridge powers up and the internal fans begin operating.
The Power Bridge then runs through its Power On Self Test
(POST). During the POST (about 10 seconds), all ports on the
Power Bridge are disabled and the LEDs light up in the following
sequence: