12
N309
Regulatory statements
Intermec hereby declares that the MaxiScan 2220 has been tested and found compliant with the below
listed standards as required by the EMC Directive 89/336/EEC as amended by 92/31/EEC and by the
Low Voltage Directive 73/23/EEC as amended by 93/68/EEC:
EN55022 (1992)
EN50082-1 (1998)EN60950 (1993)
USA:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. It generates, uses and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause interference to radio communications. If this equipment causes
interference, the user will be required to correct the interference at the user’s own expense.
This equipment complies with the UL 1950 standard. This equipment must not be connected by the RJ connectors
to any type of telecommunications circuits.
Canada:
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
This equipment complies with the UL 1950 standard. This equipment must not be connected by the RJ connectors
to any type of telecommunications circuits
Cet équipement est conforme à la norme UL 1950.
Cet équipement ne doit être connecté par les connecteurs RJ à
aucun type de circuits de télécommunication.
Australia-New Zealand:
This equipment has been tested and found to conform to the Australian EMC
framework concerning Class B digital devices, prescribed by the Australian and New-Zealander
standard AS/NZS 3548.
Mexico:
Este equipo cumple con la certificatión NOM.
The information contained in this document is for informational purposes only and is subject to change without
notice. No part of this document may be copied or reproduced in any manner without the prior written permission
of Intermec Technologies Corporation.
MaxiScan products are covered by patents issued or pending in the USA and other countries.
The word Intermec, the Intermec logo, MaxiScan and EasySet are either trademarks or registered trademarks of
Intermec.
Throughout this document, trademarked names may be used. Rather than put a trademark (™ or ®) symbol in
every occurrence of a trademarked name, we state that we are using the names only in an editorial fashion, and
to the benefit of the trademark owner, with no intention of infringement.
North America / Asia Pacific / Latin America
• 6001 36th Avenue West, PO Box 4280, Everett, WA 98203-9280
Tel: +1 425 348 2600 • Fax: +1 425 348 2833 • U.S. service and technical support, tel: 1.800.755.5505 • Canadian
service and technical support, Tel: 1.800.688.7043
Europe / Middle East / Africa
• Sovereign House, Vastern Road, Reading RG1 8BT, England
Tel: +44 (0) 118 987 9400 • Fax: +44 (0) 118 987 9401
Internet
: http://www.intermec.com
:
Technical information
: http://datacapture.intermec.com
© 2001 Intermec Technologies Corporation.
3-430049-01-012
Revision level :
All rights reserved.
