Intermec CS40 Vehicle Power Adapter, Руководство пользователя

Страница: 74 / 152

Chapter 7 — Configuring the Computer
62 CS40 Mobile Computer User’s Manual
About Wi-Fi (802.11b/g Radio) Communications
To add your mobile computer to your Wi-Fi network so you can
transfer data wirelessly, you need to enable the Wi-Fi radio and
configure radio parameters. You can use:
• Intermec Settings to enable the Wi-Fi radio. For help, see the next
section,
“Enabling the Wi-Fi Radio With Intermec Settings.”
• ScanNGo bar codes to enable the 802.11 radio and configure the
default settings for Funk security or Microsoft Wireless Zero
Configuration (WZC) security. For help, see
“Enabling the Wi-Fi
Radio With ScanNGo Bar Codes” on page 63 .
Enabling the Wi-Fi Radio With Intermec Settings
By default, the Wi-Fi radio is disabled. You need to enable the radio to
add your mobile computer to your Wi-Fi network.
To enable the Wi-Fi radio with Intermec Settings:
1 Start Intermec Settings by tapping Start > Settings > System >
Intermec Settings .
2 Tap Communications > 802.11 Radio > Radio Enabled .
3 Select the Radio Enabled check box and tap OK .
By default, the computer selects Funk security and enables DHCP.
4 Use Intermec Settings to configure the parameters you need to
communicate with your network.
5 Configure Wi-Fi security. For help, see “About Wireless Security”
on page 70 .
Make sure all components with antennas are at least 30 cm (1 ft)
apart when power is applied. Failure to comply could result in
equipment damage.