Intermec CS40 Vehicle Power Adapter, Руководство пользователя

Страница: 111 / 152

Chapter 9 — Troubleshooting and Maintaining the Computer
CS40 Mobile Computer User’s Manual 99
Troubleshooting Operating the Computer
Use this section to troubleshoot problems that may prevent you from
being able to operate the computer.
The scanner will not read the bar
code label.
•
Aim the scanner beam to cross entire
bar code label in one pass. Vary the
scanning angle.
•
Check the quality of the bar code label.
Scan a bar code label that you know
will scan. Compare the two bar code
labels to see if the bar code quality is
too low. You may need to replace the
label that you cannot scan.
•
Make sure the bar code symbology is
enabled and configured correctly. Use
Intermec Settings to check the
symbologies. Expand
Data Collection
> Symbologies beneath devices listed
(scanner, virtual wedge) to check and
enable symbologies, then scan the bar
code label again.
•
Make sure the computer application is
expecting input from a bar code. You
may need to type this information
instead.
Problem Solution
Problem Solution
You tap the screen and nothing
happens. Align your screen. For help, see “Aligning
the Screen” on page 23 .
The computer appears to be
locked up and you cannot enter
data.
•
Press and hold the
Power
key for ten
seconds to warm boot the computer.
•
Try reloading the firmware. For help,
see
“Updating the System Software”
on page 89 .
•
If the computer does not boot or reset,
contact your Intermec representative
for help.