10. Press the reset switch for three to five seconds. The
display will now show 12:00 A.M. and Event #1. The
timer is now ready for programming. Refer to the chart
below and enter the scheduled events (set points)
required.
EVENT
TIME
On 1
Off 2
On 3
Off 4
On 5
Off 6
On 7
Off 8
Programming Steps
Refer to programming instructions on time switch door
label and note the following:
• The MANUAL/AUTO selector can be used to temporarily
override the program. Under normal operation the
selector should be in the AUTO mode. The MANUAL
mode maintains the program but prevents the loads
from automatically switching.
• The other selector switch is used to set the time of day
(TIME SET), the program information (PROGRAM) or to
run the program (RUN). FOR A PROGRAM TO
FUNCTION PROPERLY, THE TWO SELECTOR
SWITCHES MUST BE IN THE AUTO AND RUN
POSITIONS.
• The RESET switch is used only prior to initially programming
the time switch or to erase all programmed set points.
• By holding the hour and/or minute buttons depressed
you can achieve a fast roll of the displayed time. This is
useful when setting the time of day or setting the
programmed set points (events).
• Up to 4 ON and 4 OFF set points (8 events) can be
programmed.
• The load can manually be switched ON or OFF at any
time only if the selector switch is in the RUN mode by
pressing the ON/OFF button.
• Pressing the ON/OFF button two times in the
PROGRAM mode causes the event time displayed to be
removed from the program. The display will show 0:00
and the Event (1 through 8).
To Operate Timer
After programming is complete, move the selector
switches to the RUN and AUTO positions. The time switch
will follow the scheduled program but will not immediately
“catch up” to the presently programmed load condition; the
time switch will “catch up” at the next scheduled ON or
OFF setpoint. If necessary, press the ON/OFF button to
turn the load on or off.
LOAD STATUS INDICATOR
ON or OFF
Install Jumper Only If
Timer Input and Load
Voltage Are The Same.
Otherwise provide a
separate source of load
power to terminal 3.
PROGRAM
-
MING
BUTTONS
MANUAL/A
UTO
SELECTOR
PRO -
GRAM
SELEC-
EVENT
INDICA-
PROGRAM
-
MING/
MANUAL
LOAD
AM ON
5:20
FIG. #4
ET102C SPST
FIG. #5
ET104C DPST
FIG. #6
