Intermate Twinax Connection LX T-04, Руководство пользователя

Страница: 15 / 81

I n s t a l l a t i o n
I n t e r m a t e L X T - 0 4 15
System Attachment
When your Intermate LX T-04 is configured, and the configuration is verified
by a test printout, it is time to connect it to the IBM host.
The AS/400 configuration is easiest done using the Auto Configuration. The
LX T-04 then configures as a
*4214
printer device.
Make sure that the printer is switched off and the T-cable and the twinax cables
are properly attached.
Then follow these steps to configure your AS/400 and the LX T-04.
1. Find a free device address by printing a device address chart using the
CL command:
PRTDEVADR
2. Set the device address (0-6) on the LX T-04's address switch.
3. Enable Auto Configuration using the CL command:
CHGSYSVAL SYSVAL(QAUTOCFG) VALUE('1')
4. Connect the LX T-04 to the network and switch the printer ON.
If the device address has been changed from another valid value (0-6),
you must confirm by stepping the address switch one step forward, and
then back. The new device address is confirmed by a printed message.
5. Verify that the AS/400 has detected a new device type
*4214
by using
the CL command
WRKDEVD PRT*
and pressing F5 (refresh)
continuously.
6. Start the Printer Writer for the device:
STRPRTWTR DEV(PRT08)