Interlogix ZeroWire ZW-6400H, Руководство пользователя

Страница: 10 / 50

‐ 10 ‐
Arm your system in Stay Mode
Use Stay Mode when you are staying in the premises and you want the perimeter protected whilst
allowing you to move around inside without setting the alarm off. This gives you peace of mind
even when you are at home.
For example, Stay Mode is often used at night to arm sensors around the perimeter of your home
and bypass all internal movement sensors. This will allow you to move around inside your home
without causing the system to sound an alarm. Perimeter sensors will still be active to detect
intruders. The security of your home in Stay mode is dependant on the type and number of
sensors you have installed and are active in Stay mode.
Normally all Stay Mode sensors must be secure before you can arm in Stay Mode.
If the Ready Light is flashing green then “forced arming” is enabled. This means some sensors are
not secure but you can still arm your security system. Read more about the Forced Arming Feature
on page 9.
You may arm your system by entering your user PIN code:
1.
STATUS
Check status key is green. Close
all protected doors and windows.
If you have movement sensors in
your “stay mode”, have everyone
leave those partitions.
2.
STAY
Select the Away Mode
3.
4.
Stay within the protected
partitions
or if your service provider has enabled the quick arm feature, you can simply touch the Stay key:
5.
STATUS
Check status key is green. Close
all protected doors and windows.
If you have movement sensors in
your “stay mode”, have everyone
leave those partitions.
6.
STAY
Select the Away Mode
7.
Stay within the protected
partitions
If an armed sensor is alarmed whilst your security system is in the Stay mode, it will sound a
warning tone on your ZeroWire and start a timer. At the end of the Stay Mode Entry Time your
sirens will sound. Your service provider predetermines this warning time at the time of
installation.
EXIT DELAY BEEPS
ENTER
EXIT DELAY BEEPS
USER PIN CODE