Installation Step 3
To connect the doorbell camera to power:
1. Connect the existing doorbell wiring to the rear of
the doorbell assembly. The two wires can be
connected to either terminal on the rear of the
assembly.
2.
If the existing wires are not long enough to
properly connect the doorbell camera
: Use the
included connectors and wires to extend the
existing wires. Insert the wires into the connector
and then tighten the screws until the wire
connection is secured.
Note:
Connect the included resistor to the doorbell if
no electrical or mechanical chime is connected.
1. Wires
2. Connector
3. 10Ω resistor
4. AC transformer (included
with RS-3241 only)
10
P/N 466-2950-EN • REV B • ISS 07MAY18 © 2018 United Technologies Corporation. All rights reserved.
