•
Concord systems can accommodate one PIV module per
partition. For multiple partition installations, each module
must be connected to a separate phone line and speaker.
•
Give your customer the ability to unplug their system by
connecting the phone line with an RJ-31X jack. This
ensures your customer can unplug the system in cases of
malfunction where they must also use the phone.
•
Mount the module inside the panel cabinet or use the
optional plastic wall-mount housing (part no. 60-800).
•
Use four-conductor, 22-gauge or larger diameter stranded
wire to connect the module to the panel.
•
Install the module inside the panel cabinet or as close to
the cabinet as possible.
•
Set each bus module with different bus unit numbers
(must be manually set for Concord panels v1.0-1.6).
•
Remember that the module draws a maximum 600 mA
from the panel’s power supply.
•
When using panel power to supply bus or hardwired
devices,
do not
exceed the panel’s total power output.
Refer to specific panel
Installation Instructions
for further
detail.
Tools and supplies
•
Slotted screwdrivers
•
3/8”-drive drill and drill bits
•
Wire cutter/stripper
•
Screws and anchors (included)
•
Optional plastic housing (60-800, not included)
•
Four-conductor, 22-gauge or larger stranded wire
•
RJ-31X Phone Jack (not included)
•
DB-8 Cord (included with Concord cabinet)
•
Support standoffs (included with Concord cabinet)
Installation
When installing the PIV module, mount the module inside a
panel cabinet or on a wall.
Caution:
To prevent damage to the panel or module, remove
the panel’s AC power transformer and disconnect the backup
battery before installation.
You must be free of static electricity when handling electronic
equipment. Touch a grounded metal surface before touching a
circuit board.
Mounting the Module in a Concord Panel Cabinet:
1. Remove panel AC power and disconnect the backup
battery.
2. Install support standoffs (see Figure 2 below).
Figure 2: Installing support standoffs
Support
Standoffs
3. On the panel cabinet, slide the top of the backplate on to
the module’s center and top-left mounting clips (see
Figure 3 below).
Figure 3: Mounting the module inside a panel cabinet
Module Mounting
Clips (6)
Card on Module
Back Plates
Panel Cabinet
(Cover not shown)
Support
Standoff
4. Raise the backplate assembly until it rests on the cabinet’s
left wall tab and the standoffs align with the backplate’s
lower holes (see detail in Figure 3 above).
Mounting the Module with Optional Plastic Housing:
1. Loosen cover screws and remove cover (see Figure 4 on
page 3).
2
SuperBus 2000 Phone Interface/Voice Module Installation Instructions
