It is recommended to use Internet Explore 8.0 or
above to access the Managed Switch. If the Web
interface of the Managed Switch is not accessible,
please turn off the anti-virus software or firewall
and then try it again.
Terminal Setup
To configure the system, connect a serial cable to a
COM port
on a PC or notebook computer and to RJ45 type of serial port
of the Managed Switch.
Figure 1:
Managed Switch Console Connectivity
A terminal program is required to make the software
connection to the Managed Switch.
1. Run terminal program
on the OS.
2. When the following screen appears, make sure that the
COM port should be configured as:
♦
Baud
: 115200
♦
Data bits
: 8
♦
Parity
: None
♦
Stop bits
: 1
♦
Flow control : None
Figure 2:
COM Port Configuration
Logon to Console
Once the terminal is connected to the device, power on the
Managed Switch and the terminal will display “running testing
procedures”. Then, the following message asks to log-in user
name and password. The factory default user name and
password are shown as follows and the login screen in Figure
3 appears.
Username:
admin
Password:
admin
Figure 3:
POC2502 Managed Switch Console Login Screen
The user can now enter commands to manage the Managed
Switch. For a detailed description of the commands, please
refer to the following chapters.
1. For security reasons, please change and
memorize the new password after this first
setup.
2. Only accept command in lowercase letter
under console interface.
Configuring IP Address
The Managed Switch is shipped with default IP address shown
below.
IP Address:
192.168.0.100
Subnet Mask:
255.255.255.0
To check the current IP address or modify a new IP address
for the Switch, please use the procedures as follows:
Show the current IP Address
1.
At the
“POC2502 Series#”
prompt, enter
“show ip ”.
2.
The screen displays the current IP address as shown in
Figure 3.
Figure 3:
IP Information Screen
2
IFS POC2502 Series Quick Start Guide
