Interlogix IFS MC252-4P-1S, Руководство пользователя

Страница: 3 / 9

P/N 1073625-EN • REV A • ISS 17APR19 3 / 9
LED indicators
System
LED Color Function
P1 Green Lit : indicates power 1 has power.
P2 Green Lit : indicates power 2 has power.
FAULT Red Lit : indicates either power 1 or power 2 has
no power.
30W Orange Off: indicates the PoE usage is less than 14
W.
Blinking: indicates that the PoE usage is
around 15 to 29 W.
Lights:
indicates the PoE usage is
around /over 30 W.
60W Orange Blinking:
indicates that the PoE usage is
around 45 to 59 W.
Lit:
indicates the PoE usage is around /over
60 W.
90W Orange Blinking: indicates that the PoE usage is
around 75 to 89 W.
Lit: indicates the PoE usage is around /over
90 W.
120W Orange Blinking: indicates that the PoE usage is
around 100 to 119 W.
Lit: indicates the PoE usage is at the
maximum.
Per 802.3at PoE+ 10/100BASE-TX Interface (Port 1 to Port
4)
LED Color Function
Link/ACT Green Lit : indicates the port is successfully
connecting to the network at 10 Mbps or
100 Mbps.
Blinking : indicate s that the port is actively
sending or receiving data.
PoE in
Use
Orange Lit : indicates the port is providing DC in-line
power.
Off : indicates the connected device is not a
PoE powered device (PD) .
Per 10/100BASE-TX Interface (Port 5 of NS2052-4P-1T)
LED Color Function
Link/ACT Green Lit : indicates the port is successfully
connecting to the network at 10 or 100
Mbps.
Blinking : indicate s that the port is actively
sending or receiving data.
Per 100FX SFP Slot (Port 5 of MC252-4P-1S)
LED Color Function
Link/ACT Green Lit
: indicates the port is successfully
connecting to the network at 100 Mbps.
Blinking
: indicate s that the port is actively
sending or receiving data.
Switch upper panel
The upper panel of the industrial PoE+ switch consist s of one
terminal block connector within two DC power inputs .
Figure 2 below shows the upper panel of the industrial PoE+
switch.
Figure 2: Industrial PoE+ switch upper panel
Wiring the power inputs
The six - contact terminal block connector on the top panel of
industrial PoE+ switch is used for two DC redundant power
inputs. F ollow the steps below to insert the power wire.
Caution:
When performing procedures like inserting the wires
or tightening the wire- clamp screws, ensure that the power is
OFF to prevent electrical shock.
1. Insert positive and negative DC power wires into contacts
1 and 2 for Power 1 or 5, and 6 for Power 2.
2. Tighten the wire- clamp screws for preventing the wires
from loosening.
1 2 3 4 5 6
Power 1 Fault Power 2
+ - + -
Notes :
1. The wire gauge for the terminal block should be in the
range between 12 and 24 AWG.
2. The DC power input range is 12 to 48 VDC .