800-grill.de | [email protected]
24
elektro Pure / XL / XLc
Remove meat and let rest after cooking
The strong radiant heat at a high temperature setting between 650 ° C and 850 ° C ensures rapid
browning or crusting. In most cases, it is recommended that after strong irradiation. you remove the
meat and let it rest. This can be done at reduced temperature in the upper grill room (rail 1-5) or better
still in the lower grill room (rail 7-9}, or even directly in the drip tray in the lower room of the grill
attachment (resting area). For this, you can remove the drip tray with the guide handle. (Caution, this
can be hot and should be placed on a fireproof base).
Drip tray
By default, the drip tray should be inserted in rail 6 during the grilling process. It can get hot and, just
like the grid, should only be operated with the guide handle.
Although the dripping grease drains off quickly into the grease trap, a thin film of grease may adhere
to the surface of the drip tray. Due to the strong infrared radiation, it can burn into the surface. From a
practical point of view, it is recommended to remove the drip tray briefly between rounds of grilling and
drain with water or wipe with a damp cloth.
The preparation of a steak is dived into the following steps:
1.
Pre-heat device.
2.
Position and insert the meat.
3.
Grilling one side (1-4 minutes depending on the type of meat. see table).
4.
Grill the first side (1-4 minutes depending on meat and distance. see table).
5.
Grill the other side (1-4 minutes depending on the type of meat. see table).
6.
Grill the second side (1-4 minutes depending on meat and distance. see table).
7.
Let the meat rest.
8.
Enjoy!
Turn off and allow to cool down
After using the appliance, the cooling fans remain in operation for some time until the heater has drop-
ped below a temperature of 60 °C. Do not pull the plug, do not turn off the unit at the main switch on
the back of the device as while the fan is running the unit may overheat.
Cleaning and Care
The device may only be cleaned after it has cooled down completely, the main switch has been swit-
ched off and the earthing contact plug has been removed from the socket and the device is therefore
completely disconnected from the mains.
First remove the grill grate, the drip tray, the drip tray and then the grill attachment. The grill should be
completely sprayed with an appropriate cleaner. Pay attention to metal compatibility when choosing a
cleaner. Let the cleaning agent act, and if the grill insert is very dirty spray several times. After a
sufficient reaction time, thoroughly rinse the insert with the aid of a washing-up brush with plastic
bristles. Do not use abrasives. Wire brushes or steel sponges to prevent scratches and corrosion.
The grill room and the housing must be regularly and thoroughly cleaned with a slightly damp cloth.
Do not spray cleaners in or on the device. Detergent should be applied to the appliance using a cloth.
Prevent strong mechanical loads on the heating during the cleaning process. Attention: residues
may ignite, so clean thoroughly.
Note: The removable parts are made of high quality stainless steel and are suitable for
cleaning in the dishwasher.
