40
Windows NT Workstation 4.0
Depending on your system’s configuration, you will need some or all of the following system
software during the installation process:
u
Windows NT Workstation CD-ROM
u
Driver software for the on-board SCSI adapter
u
Driver software for the on-board networking adapter
u
Driver software for the installed video display adapter
u
Quick-Fix Engineering (QFE) update software
u
StudioZ software
Follow the instructions in Microsoft’s Start Here to install Windows NT Workstation 4.0. As
you install the operating system:
u
You must bypass automatic SCSI detection and manually install the Adaptec SCSI driver.
u
You can safely select the default responses for any other options during the Setup process.
u
Allow Setup to configure the network only if you have an installed network adapter, and
the system is connected to the network.
u
When prompted to create an Emergency Repair Disk, do so.
After installing the operating system:
u
Install drivers or other system software from any backup diskettes. System software
delivered on backup diskette is usually more current than system software on the
operating system CD-ROM.
u
Complete the installation tasks described later in this chapter.
u
Configure the system as described in Chapter 2, “Configuring the System.”
u
Perform any additional installation and configuration tasks described in the Late-Breaking
News document delivered with your system.
u
Install the StudioZ software. Refer to the StudioZ documentation delivered with the
system for detailed installation and configuration information.
u
You can install additional accessories for the sound processor, available from the
Intergraph Bulletin Board Service (IBBS) or from vendor bulletin boards pointed to by
the IBBS.
