4
Assemble the Monitor Table
Remove the monitor table from the packing box. Refer to the documentation delivered with the KI
workstation furniture for detailed instructions for assembling the monitor table.
Assemble the Digitizer Table
To assemble the digitizer table:
1. Remove the digitizer table top assembly from the packing box. Remove all packing materials.
Place the table top assembly face down on a carpeted floor or on the packing materials.
2. Install the peripheral equipment module (PEM) bracket onto the underside of the digitizer table
top. Place the PEM bracket upside down with the open side of the PEM bracket facing away from
the table top. Install the four #5x 0.75-inch Phillips wood screws to mount the bracket to the table
top.
NOTE
Position the angled side of the bracket toward the front of the digitizer table top.
3. Remove the digitizer stand from the packing box. Remove all packing materials and place the
digitizer stand on the digitizer table top.
4. Refer to the documentation delivered with the KI workstation furniture for instructions for securing
the digitizer stand to the digitizer table top.
5. Turn the assembled digitizer table upright.
6. Push the handle grommet into the opening for the height adjustment handle, and then install the
handle.
Install the Base Unit and Keyboard
Remove the TDZ workstation base unit and keyboard from their packing boxes. Refer to the TDZ
system’s hardware documentation for setup instructions.
Install the Monitor
WARNING
The monitor is extremely heavy and could cause serious personal injury if dropped. Two
persons are required to lift and mount the monitor into place.
Remove the monitor from the packing box and place it on the monitor table.
Install the Interface PEM
The interface PEM is the electronics interface for the two-handed controller and the digitizer table.
To install the interface PEM:
1. Remove the interface PEM and its power cord from the packing box. Temporarily place the
interface PEM on top of the digitizer table in preparation for connecting the cables to the PEM.
Содержание ImageStation Z and use
Страница 1: ...ImageStation Z Installation and Use August 1997 DHA023320 ...
Страница 4: ......
Страница 24: ...20 ...