Intergraph ErgoView DFED3607M, Руководство по установке, Страница: 10 / 24

6
4. Thread the two M3x12mm Phillips pan head screws with M4 oversized washers through the
collar tabs and into the monitor housing. Do not tighten the screws yet.
5. Thread the four M5x25mm Phillips flat head screws through the bottom of the cove r plate
(attached to the bottom of the collar) and into the monitor housing.
6. Tighten all screws.
See “Connecting the Cables” to finish setting up the ErgoView stand.
Hitachi OEM Monitor
The hardware kit (MKIT120) used to install the Hitachi monitor contains the following items:
u
One monitor cover plate, CFAB329E
u
One pivot cover, CFAB331E
u
One adapter bracket, CFAB330F (MDSP139)
u
One adapter bracket, CFAB250G (MDSP147)
u
One rear bracket, CFAB331F
u
OEM monitor collar, MMSA3530
u
Six M4x8mm screws, CPHM022
u
One-inch foam tape CPTP076 (for CFAB329E)
u
Three-quarter-inch adhesive tape CPTP077 (for CFAB331E)
Removing the Swivel Base
WARNING The monitor is heavy and could cause serious personal injury if dropped. Two persons should
lift and carry the monitor.
1. Unpack the monitor from its shipping carton.
2. Verify that the monitor power cord is supplied.
3. Turn the monitor onto its side.
WARNING Do not set the monitor on its display screen. Damage may result.
4. Rotate the base until the two screws can be seen.
5. Remove and retain the two screws.
6. Slide the base to the back of the monitor and set the base aside.
Attaching the Adapter Bracket
1. Place the appropriate adapter bracket onto the bottom of monitor. Ensure the holding latches are
secured inside the slots in the monitor frame. See the following figure.