PCI-4302
Interface Corporation
-20-
The control panel applet configures the following parameters when the device is opening.
Table 3.1 Driver Software Parameters
Parameter
Description
Default Setting
Board number
Specify the same number as RSW1 setting on the board.
0
System controller
Select
Yes
to configure the board as the System
Controller.
Yes: Controller-in-charge
No: Talker/Listener
Yes
Primary address
Assign a different primary address, in the range of 00h
through 1Eh to each interface in the system.
00 (h)
Secondary address
Freely assign any value in the range of 60h through 7Eh.
Some GPIB devices have or need no secondary address,
specify FFh in the
Secondary address
box.
FF (h)
Send/receive time-out
Specify enough time for completing data transfers.
100 (
×
100 ms)
Event time-out
Specify an amount of time within the range of 1 through
65535 for waiting to detect events.
100 (
×
100 ms)
GPIB command
time-out
Specify an amount of time within the range of 1 through
65535 for the time-out of multi-line messages and GPIB
commands.
100 (
×
100 ms)
Source handshake
timing
Select
Very high speed
(350 ns),
High speed
(500 ns),
or
Normal speed
(2 µs) for the settling time T
1
for
multi-line messages.
Note: We recommend to change the handshake timing
when an error message appears.
Very high speed
Send delimiter
terminating on write
Receive delimiter
terminating on read
Select the proper parameters that connected GPIB
devices support.
CRLF + EOI
STB time-out
Specify an amount of time within the range of 1through
255 for waiting to receive a status byte from the device.
10 (
×
100 ms)
Parallel poll execution
timing
If your system has optical fiber cables, select
10 microseconds
.
2 microseconds
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
