15
o
Coil Nailer
Drives Wire Collated Nails (1-1/4" to 2-1/4" / 32 to 57mm)
Model No. CN55-15
Item No. 65530
8
Interchange Brands
Operator’s Manual
22 .
KEEP ALL SCREWS AND COVERS MOUNTED TIGHTLY IN PLACE.
Keep all screws and covers tightly mounted . Check their condition periodically .
Never use the nailer if parts are missing or damaged .
23 .
DO NOT USE THE WRONG FITTING ON NAILER.
The nailer and air hose must have a hose coupler so that all pressure is removed
from the nailer when the coupler is disconnected . The connector on the nailer
must not hold pressure when the air supply is disconnected . If the wrong fitting is
used, the nailer can remain charged with air after disconnecting and thus will be
able to drive a nail even after the air line is disconnected, possibly causing injury .
24 .
DO NOT LOAD FASTENERS WITH TRIGGER PULLED OR SAFETY/PUSH
LEVER DEPRESSED.
When loading fasteners into the nailer or when connecting the air hose:
Do not pull the trigger
Do not depress the safety/push lever
Keep the nailer pointed downward
25 .
CHECK FOR LIVE WIRES.
Avoid the risk of severe electrical shock by checking for live electrical wires that
may be hidden by walls, floors or ceilings . Turn off the breaker switch to ensure
there are no live wires .
26 .
HOSES.
Air hoses should be professional grade and have a minimum of 150 psi working
pressure . Make sure that the hose is securely fastened . If there is any damage to
the hose, replace it before using the nailer .
27 .
PLACE NAILER PROPERLY ON WORK PIECE.
Do not drive fasteners on top of other fasteners or with the nailer at too steep of
an angle . The fasteners can ricochet and hurt someone .
28 .
BE CAREFUL OF DOUBLE FIRING DUE TO RECOIL.
If the safety/push lever is unintentionally allowed to re-contact the work piece
following recoil, an unwanted fastener will be driven .
In order to avoid this undesirable double fire:
Intermittent operation ﹙trigger or single firing﹚
(not available on all models)
1﹚ Set the switching device to SINGLE ACTUATION MECHANISM .
2﹚ Pull the trigger rapidly and firmly .
Continuous operation ﹙safety/push lever firing﹚
1﹚ Do not press the nailer against the wood with excessive force .
2﹚ Separate the nailer from the wood as it recoils after fastening .
29 .
DO NOT DRIVE FASTENERS CLOSE TO THE EDGE OR CORNER OF THE
WORK ESPECIALLY WHEN USING THIN MATERIAL.
The work piece is likely to split and the fastener could fly free and hit someone .
30 .
NEVER DRIVE FASTENERS FROM BOTH SIDES OF A WALL AT THE SAME
TIME.
The fasteners could be driven into and through the wall and hit a person on the
opposite side .
31 .
DO NOT DISCONNECT AIR HOSE FROM NAILER WHILE FINGER IS ON
THE TRIGGER.
The nailer can fire when it is re-connected to an air supply .
