Inter-Track IT-B240, Руководство пользователя

Страница: 7 / 14

All pipe plugs have been installed.
1.
With 2 sets Square Neck Screw(No. 56), Arc
Washer (No.42),
S
pring washer (No. 59) & Lock
Nut (No.49) attach front foot tube (No. 5) on main
Frame (No.4).
2.
With 2 sets Square Neck Screw(No. 56), Arc
Washer (No.42), Spring washer ( No.59) & Lock Nut
(No.49) attach Rear foot tube(No. 1 )on Main
frame ( No.4).
3. A. Connect the Meter wire (No.16&.17) of the upper and lower sections of the electronic table connection, and then
connect the terminal of the lower end of the 8- section spinner body (No.31) firmly with the re sistance cable
(No.32).
(Note: first of all the output adjustment knob to the "+" direction to the end (at this time the output of the spinner
terminal extension to the longest), according to the figure of the joint terminal sleeve in the output adjustmen t wire
connection hook, pull up the output adjustment of the upper end stuck into the box slot. If the upper end of the
output fine adjustment body line cannot just be stuck into the adjustment box slot, please turn the lower end of the
adjustment box nut to the appropriate position, so that the output fine adjustment body line at the top of the clip
just stuck into the adjustment box slot. (See Figure 3- A, B and C )
B :
H
and over Handlebar support (No.7) set into the Main frame (No.4) to take over by 4 set s of Half-Roundhead Hex
Bolt (No.50), Spring washer(No.59) and ARC washer (No.42) will hand over Handlebar support (No.7) connected to
the frame (No.4) tighten. (See Figure3-D)