Please read the installation instruction before use and keep it for possible future use.
CAUTION: This product should only be installed by a licensed installer.
MANUAL IL-
Dimensions
Installation led indicator including test button function
Indicator lamp function
Dipswitch settings inverter
Precautions
Open the cover of the module and connect the battery to the inverter at the designated location.
1. Connect the white DC cable [
To led
] to the led fixture.
2. Connect the white DC cable [
To Driver]
to the led driver.
3. Connect the power supply of the led driver of the led fixture to 230V.
4. Connect the Schuko power cord to a wall outlet or disconnect the power cord and connect the emergency
lighting module directly to the 230V wiring.
1. Determine the location of the indicator lamp and make a Ø20mm hole.
2. Remove the white edge of the indicator lamp with a small screwdriver and also remove the second
underlying white rim.
3. Place the black indicator lamp in the drilled hole and replace the white rings.
4. Now place the assembly back into the drilled hole.
2 Watt (standard)
3 Watt
5 Watt
7 Watt
Red, continuous
Battery is being charged
Green, continuous
Battery is fully charged
Green, slowly blinking
Monthly test mode (press for 5 seconds)
Green, fast blinking
Annual test mode (press for 7 seconds)
OFF
Emergency lighting is in operation
• This product must be installed by a licensed installer in accordance with local standards and electrical codes.
• Always turn off the power before installation.
• The led inverter must be used with a lithium battery (LiFePO4 6.4V), this is standard supplied.
• The LED inverter is intended for use in emergency lighting only.
35 mm
300 mm
112 mm
Installation of emergency lighting module
