I N S T A L L A T I O N M A N U A L
E D G E ™ D I V I N G S Y S T E M
8
EDGE-IM Rev. 6/08 (BBK-EDGE INSTAL)
When finishing the deck surface, maintain a level deck where the jig bolts project out so the dive
stand makes uniform contact with the deck surface. Allow the cement to fully cure before bolting
the dive stand to the jig bolts.
Before bolting the dive stand to the jig bolts, chisel away any excess concrete that may have built
up around the jig bolts then remove the protective yellow rubber bolt caps.
The top surface of the diving board from the deck end to
the tip end shall be level or have an upward slope of 5/8"
per foot maximum. Elevation difference shall not exceed
6" from the deck end to the tip of the board. There shall
be no downward slope towards the water. The slope shall
be measured using a level as shown in the graphic to the
left.
ONLY ONE PERSON ON THE JUMP BOARD AT A TIME, WITH A MAXIMUM WEIGHT
OF 300 LBS.
INSTALLATION INSTRUCTIONS:
Continued
FIG. D
Edge Springs
FIG. E
Edge Fiberglass Base
POOL WATER
POOL WATER
STEP ONE:
Lay the Edge board upside down on the box it was shipped in. Attach the Edge Springs to the board
with hardware kit EDGE-M. The long leg of the spring faces towards the pool as shown in Figure D.
Use exploded view on page 9 for reference. Hand tighten only at this point
.
STEP TWO:
Lay the base upside down on the springs and align the 3 holes in each spring center to the base.
Orient Edge Base to pool as shown in Figure E. Use hardware kit EDGE-SP and bolt springs to base.
Use exploded view on page 9 for reference. Tighten the 6 bolts from base to springs at this time
to 20-25 FT-LBS.
STEP THREE:
Turn the assembly over and tighten the board to spring hardware that was only hand tightened in step one.
STEP FOUR:
Place the Edge stand over the four jig bolts and secure with hardware kit TS-BK. Tighten the Stand
Anchor Hex Nuts to 40-45 FT- LBS. Do not over tighten.
The Diving Board must be installed according the below board leveling instructions:
HARDWARE NOTE: Use a small dab of anti seize lubricant (included) on all bolt threads.
