Intense TRACER 279 EXPERT, Руководство пользователя

Страница: 25 / 34

49 48
G E O M E T R Y
FLIP CHIP...
CONTINUED
S
T U
STEP 13
Using a 5mm Allen key on the drive-side of the bike
screw the D-Lock Nut onto the D-Lock Bolt (S) . You’ll
need to apply a little pressure on the end of the bolt on
the left (non-drive side), just so that the bolt doesn’t get
pushed out. Go slowly with this step, being careful not
to cross thread the nut or bolt. Torque to 16Nm (T) .
STEP 14
Pull the cables back through the downtube of the
frame so that they are neat and tidy (U) . Replace the
rear wheel and torque the rear axle on the drive-side
of the bike to 11Nm (see page 16).
YOU’RE DONE.
Now simply get out and ride your favorite trails. If at
any point you want to go back to the HI setting to
better suite any specifc terrain or perference, you
can just simply repeat this process and reset to the
alternate postion. Please note that the change in Flip
Chip oreintation may result in a small spring preload
adjustment in order to achieve the perfect 30% sag
numbers that you had already established in the
previous setting.
Please refer to the geometry chart located on page
52 for further information on how ‘Flipping the Chip’
affects the geometry of your bike.