9
6. Cable should be straight in the groove, and cannot beyond the groove in case of holding back the inlet and outlet holes. Cables sho uld be
banded and fixed when they are out of the groove;
7. User cable should be separated from the power lines. Cables, power lines and grounding lines cannot be overlapped and mixed when they
are in the same groove road. When cable is too long, it cannot hold down other cable, but structure in the middle of alignmen t rack;
8. Pigtail cannot be tied and swerved as less as possible. Swerving radius cannot be too small (small swerving causes terrible loss of link). Its
banding should be moderate, not too tight, and should be separated from other cables;
9.It should have corresponding simple signal at both sides of the cable for maintaining.
【
Specifications
】
Ethernet ports
Standard: 10Base-T, 100Base-TX
Protocol: Support TCP, UDP, APR, ICMP and DHCP
Signal: Rx+, Rx-, Tx+, Tx-
Speed: 10/100Mbps
Working: Full-duplex and half duplex
Working mode: Support TCP Server and Client
Transfer distance: 100m
Serial ports
Serial port number: 4 port RS-232 or 4 port RS-485/422
RS-232 signal: DCD, RXD, TXD, DTR, GND, DSR, RTS,
CTS
RS-485 signal: D+, D-, GND
