IntelliSense SECURIT 900C, Руководство пользователя, Страница: 7 / 8

7
RESETTING THE ALARM SYSTEM
If the alarm is sounding, enter the user code to stop the sounders. Make
a note of the zone that caused the activation for future reference.
The panel can be programmed for Engineer Reset. It is possible that you
may not be able to reset the panel yourself. You may have to call the
Alarm Company on the number below for assistance.
A Technistore Reset is required if all LEDs light simultaneously followed
by a 5-digit series of numbers, indicated by the LEDs lighting in sequence.
You will have to call the number below for assistance. This code is given
to obtain the correct reset code number.
If a customer reset is allowed, enter the user code again to reset the
panel. If the panel does not reset
contact the Alarm Company .
Reset Type Tampers Alarms
Customer
Engineer
Technistore
Assistance
telephone number
FAULT CLEARING
SYMPTOM CAUSE ACTION
Zone LED on
continuously
Alarm activated Reset the panel.
Tone pulsing on exit Zone in Fault
Leave protected area and wait for tone
to go continuous.
Tone continues to
pulse after exit
Zone in Fault
Check for open doors, or a detector is in
fault, call your Alarm Company.
Alarm triggers on exit Timer ran out
Go quicker to exit or call your Alarm
Company to extend exit time.
Alarm triggers on entry
Timer ran out,
deviated from
entry route
Follow entry procedure, call your Alarm
Company to extend entry time.
Tamper LED stays on
after reset
Tamper fault Call your Alarm Company.
No mains light
Mains off, fuse
blown
Switch mains on. Check other mains
appliances. Call electricity supplier or
Alarm Company.
Battery LED on
Fault on battery
circuit Check mains is on. Call your Alarm
Company to check battery.
RESETTING
THE ALARM
SYSTEM
FAULT
CLEARING