Intellipure 950P, Руководство по эксплуатации

Страница: 12 / 16

Intellipure © 2021 All rights reserved.
12
Maintenance
Remove the V-Bank Main Filter and High Energy Grid Assembly
Refer to page 11 for proper instructions.
To clean the wires, use a lint free swab, either dry or moistened with denatured alcohol, clean along the length of each
wire and spring clips.
Clean the inner surfaces of the High Energy Grid material using a lint cloth moistened with denatured alcohol.
Clean the High Energy Grid surface by vacuuming between the wires using a small vacuum attachment or by using a lint
free cloth, either dry or moistened with denatured alcohol. Take care to avoid leaving large fibers snagged on the wires,
control grid, or other components of the High Energy Grid.
Make sure that any contaminant that falls to the bottom of the filter unit is removed.
In extreme cases, it may be necessary to remove the wires from the springs attached at each end to the power distribution
bars, thus allowing complete access to the inside of the High Energy Grid assembly for cleaning
as previously described. It is recommended that the manufacturer be contacted for detailed instructions should this step
appear necessary.
Vacuum the bottom of the filter seal plate section and of the filter unit to remove any particles dislodged during cleaning.
Reinstall the High Energy Grid, V-Bank Main Filter and Filter Access Door as previously instructed.
Do not install the High Energy Grid to the V Bank Filter until wires are completely dry.
CLEANING THE UNIT
Depending on contamination level, this procedure should be conducted once a year or during each filter change or if an
electrical problem occurs.
Do not install the High Energy Grid to the V Bank Filter
until wires are completely dry.
Cleaning and user maintenance shall not be made
by children without supervision.