Multi FX 1U Manual
D. TONE
Knob - This knob is active for all three modes, and it controls a simple low pass
filter. Turning it counterclockwise “dulls” the tone by decreasing the high frequency
content. This can decrease the perceived ‘liveliness’ in the reverb, or allow for
increasingly duller ‘taps’ as a delay fades out (as might happen with a tape delay).
E. AMOUNT
Knob - The function of this knob changes, depending on the mode you’ve
selected with the
FX TYPE
[A]
switch). The function for each mode is labeled beneath
the knob. Specifically:
●
REV
(reverb) mode - The knob controls the reverb’s
DECAY
time. Clockwise =
longer reverbs.
●
DLY
(delay) mode - The knob sets the number of
REPEATS
. Clockwise = more
repeats (higher feedback).
●
CHO
(chorus) mode - The knob controls the
DEPTH
of the chorus effect.
F. MIX
Knob - Sets the amount of Dry vs Wet signal sent to the
OUT L
[1]
and
OUT R
[2]
jacks. When fully counterclockwise, only the dry, unaffected signal is sent to the outputs.
When fully clockwise, only the wet, fully-effected signal is sent to the outputs. When set
to the noon position, equal amounts of wet and dry signal appear at the outputs.
Page 8
